Iron-ON decals now available!

Now you can have your own signature decals on your T-shirts (or any fabric that can be ironed)! 

Iron-ON instructions. (1 color)

1. Place decal on fabric, decal side down and smooth glossy acrylic side up.
2. Place sheet of tracing paper over decal.
3. Set iron to the cotton heat setting for cotton and polyester T-shirts, and silk setting for Nylon fabrics. It may not be possible to iron the decal onto delicate Nylon fabrics.


Step 1

4. Place iron onto decal, hold down with firm moderate pressure and move iron around the decal slowly for 10 -15 secs.
5. Remove iron, let cool for about 1 minute, until it is cool to touch.
6. Remove tracing paper and gently lift an edge of the clear acrylic sheet. If decal does not stick on the fabric, leave the acrylic as is, place the tracing paper back on, iron for another 15 secs with a little more pressure.
   

   Ironing on

7. After removing the acrylic sheet, turn iron heat down to low. Wait for a couple of minutes to allow iron to cool down. Place tracing paper back on the decal, then iron on the new decal with light pressure for a few seconds. This will ensure all the adhesive is transfered onto the fabric so that the holding will be firm and permanent.
   

   Done

I have not had any more problems than needing to iron twice on certain fabric. Usually, moving iron over decal for 20 secs(max) will do the trick.

Instructions for 2 colors or more ( This requires some planning ahead )

1. Sort out the sequence of iron on decal. Usually the largest size goes on 1st, but not always!
2. Repeat the process for ironing on the decal for the 1st layer.
3. Remove tracing paper and gently off the clear acrylic sheet.
4. Place 2nd decal, align it visually, then place tracing paper over decal. Be careful to not move the decal.
5. Iron on decal, moving around for 15 secs.
6. Let cool and check the results.
7. Repeat for each color until picture is complete. 

2 color iron on decals